View source for Button Maker Tutorial

[[File:Correct Button Back.jpg|thumb|This is what the button back should look like after you fix it. Make sure it is this way before putting it into the button maker. ]]
How to use the button maker :)
[[File:Top of silver part of the button and backward back of the button..jpg|thumb|Top of silver part of the button and backward back of the button. The pin part of the back of the button needs to be flipped to the other side. ]]
First, print out a sheet with the design you want on the button. It should fit inside a insertsizehere circle. Then, put the paper in the hole punch and line it up to where you can see the design you want punched out in the hole. Punch out the circle. Then, on the left-hand slot, place the silver part of the button, with the closed part facing up, then the design facing up, then the clear film. Slide it to where the lefthand slot is under the top part of the button maker. Place the back of the button on the right-hand slot. The backs are backward and will need to be disassembled and righted. the flat part of the pin should be on the side with a dip in the center, and the curved part of the pin should be on the flat side. Place the side with the curved part of the pin face up on the right-hand side. pull the lever down to pick up the objects on the left-hand slot, then slide to where the righthand slot is under the center and pull the lever down again. button done. :)\