Horizontal Bandsaw: Difference between revisions
From Makerpedia
edited categories |
JaneParson (talk | contribs) No edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
'''[https://docs.google.com/document/d/1qs-HVt2Dm_L4mgqAncnmIfyjGVMaBsK4/edit?tab=t.0 Before Use, Consult the Safety Check Sheet]''' | |||
[[CATEGORY:Tools]] | [[CATEGORY:Tools]] | ||
[[File:Ellis.jpg|thumb]] | [[File:Ellis.jpg|thumb]] | ||
== Introduction to the Band Saw == | == Introduction to the Band Saw == | ||
{{#Widget:yt|id=A3p03UKkqXQ}} | |||
== Terminology == | == Terminology == | ||
| Line 37: | Line 39: | ||
* [https://drive.google.com/open?id=1XluxY8ZuUMfXifsqNU_ZtYYxQ8K10cte Owner's Manual] | * [https://drive.google.com/open?id=1XluxY8ZuUMfXifsqNU_ZtYYxQ8K10cte Owner's Manual] | ||
[[Category:Machine Shop Tools]] | [[Category:Machine Shop Tools]] | ||
Latest revision as of 14:36, 11 August 2025
Before Use, Consult the Safety Check Sheet
Introduction to the Band Saw
Terminology
Safety Considerations
User Guide
Before starting a project with the Horizontal Band Saw, you must complete the safety training detailed above and consult with Aaron.
Each time you use the Horizontal Band Saw you must follow the following checklists.
Before use
- Ensure bed is free of chips
- Position work on bed
- Set work-piece guides as necessary
- Set miter angle as necessary
- Position clamp on work piece and fixture piece
- Adjust blade guides if necessary
- Ensure E-stop is disengaged
- Position blade near work-piece
- Turn on machine power
- Set down feed rate
After use
- Reset miter angle to 0 degrees
- Clear chips from bed
- Discard unusably short scrap
