Horizontal Bandsaw: Difference between revisions
From Makerpedia
edited categories |
removed woodworking category |
||
| Line 37: | Line 37: | ||
* [https://drive.google.com/open?id=1XluxY8ZuUMfXifsqNU_ZtYYxQ8K10cte Owner's Manual] | * [https://drive.google.com/open?id=1XluxY8ZuUMfXifsqNU_ZtYYxQ8K10cte Owner's Manual] | ||
[[Category:Machine Shop Tools]] | [[Category:Machine Shop Tools]] | ||
Revision as of 17:15, 14 February 2025
Introduction to the Band Saw
Terminology
Safety Considerations
User Guide
Before starting a project with the Horizontal Band Saw, you must complete the safety training detailed above and consult with Aaron.
Each time you use the Horizontal Band Saw you must follow the following checklists.
Before use
- Ensure bed is free of chips
- Position work on bed
- Set work-piece guides as necessary
- Set miter angle as necessary
- Position clamp on work piece and fixture piece
- Adjust blade guides if necessary
- Ensure E-stop is disengaged
- Position blade near work-piece
- Turn on machine power
- Set down feed rate
After use
- Reset miter angle to 0 degrees
- Clear chips from bed
- Discard unusably short scrap
